LED Lighting

If your home or business premises has the GU10 type halogen downlighters and spot lights then it is seriously worth considering changing all of them to low energy LED lamps instead of the halogen type. Often the halogen GU10s have a 50 Watt energy use whereas an LED type could between 5-7 Watts. Not only is the energy use wasteful but it can create heat in the home when you don’t need it. As an example a kitchen with 8 of these halogen GU10 lamps in downlighters would be producing 400 Watts of heat output into the kitchen.

Not all replacement GU10 LEDs are the same. For example I looked at the two specifications of two GU10 LED lamps that a home owner had recent bought that were both 5 watts energy rated, I noticed the initial Lumens output was 450 on one and 250 on the other. This in effect is 44% less light produced for the same energy use!

Reliability should be considered as well. Halogens lamps may last 2 years or less (1,500 hours) where as an LED could last 5 years (30,000 hours). If the occupant of a home can change the lamps themselves then the cost to replace is small. But if the home is rented or is occupied by persons unable to replace ceiling lamps, then the cost to change lamps is high.

When choosing LED lamps be sure to select the correct colour of “white” light. Many manufacturers offer a “warm” white which is similar to the old style incandescent lamps or a bright “cool” white which is popular in kitchens. But be careful because I have seen “unbranded” “cool white” described lamps that look a distinctly bluish white.

Similar to the low energy compact fluorescents the LED type of lamps also very slowly reduce their light outputs of the say 30,000 hours of use. Manufacturers indicate that a 30% reduction in light over a service life would be acceptable to the users. This means homes owners might enjoy slightly too bright light levels when first installed, then just about acceptable after 30,000 hours of use. It is worth noting that an excessive build up of heat in the light fitting can accelerate this light reduction over time. Once more the electrician specifying a lighting solution will choose lamps suitable for exact location/fittings installed and will ensure the installations are appropriate for the lamps.

Take care to avoid poor quality LED lamps as they could have a high initial failure rate. Quality “branded” products are an assurance for reliability.

A good electrician will be able to advise to ensure replacement low energy lamps are reliable, good service life performance, are of suitable colour, an appropriate level of brightness (lumens), and have the correct beam width for the installation.

Leave a Reply

Your email address will not be published. Required fields are marked *

To reduce SPAM please answer this question below. If required please use the circular arrow button to refresh the question : Time limit is exhausted. Please reload CAPTCHA.